2003 Toyota Highlander Base, 2.4 D, FWDFACTORY OEM SERVICE PROCEDURE

Service Data

FUEL SYSTEM SERVICE DATA SPECIFICATION (2AZ-FE)

Fuel Pressure 304 - 343 kPa (3.1 - 3.5 kgf/cm2 , 44 - 50 psi)
Fuel Injector
Resistance At 20° C (68° F) 13.4 - 14.2ohm
Injection Volume 69 - 82 cm2 (4.1 - 4.9 cu in.) per 15 seconds
Difference Between Each Cylinder 13 cm3 (0.8 cu in.) or less
Fuel Leakage 1 Drop Or Less Per 12 Minutes
Fuel Pump Resistance At 20° C (68° F) 0.2 - 3.0ohm
FUEL SYSTEM SERVICE DATA SPECIFICATION (1MZ-FE)

Fuel Pressure 304 - 343 kPa (3.1 - 3.5 kgf/cm2 , 44 - 50 psi)
Fuel Injector
Resistance At 20° C (68° F) 13.4 - 14.2ohm 6
Injection Volume 0 - 73 cm2 (3.7 - 4.5 cu in.) Per 15 Seconds
Difference Between Each Cylinder 13 cm3 (0.8 cu in.) Or Less
Fuel Leakage 1 Drop Or Less Per 12 Minutes
Fuel Pump Resistance At 20° C (68° F) 0.2 - 3.0ohm
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.