Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Toyota Corolla LE, AutomaticFACTORY OEM SERVICE PROCEDURE
Wheel Alignment - Specifications: Specifications
Front Wheel Alignment Specifications
| Cold tire inflation pressure | Tire size: P185/65R15 86S | Front, Rear | 210 kPa (2.1 kgf/cm2 , 30 psi) | ||||||||
| P195/65R15 89S | Front, Rear | ||||||||||
| Front wheel alignment | Vehicle height | Front: A (1) - B (2) | 87 mm (3.43 in.) | ||||||||
| Rear: D (4) - C(3) | 43 mm (1.69 in.) | ||||||||||
| Toe-in (total) | 0° ± 12' (0° ± 0.2°, 0 ± 2 mm, 0 ± 0.08 in.) | ||||||||||
| Rack end length difference | 1.5 mm (0.059 in.) or less | ||||||||||
| Wheel angle | Inside wheel | 37°06' (35°06' - 39°06') 37.10° (35.10° - 39.10°) |
|||||||||
| Outside wheel: Reference | 31°49' 31.82° |
||||||||||
| Camber | -0°32' ± 45' (-0.53° ± 0.75°) | ||||||||||
| Right-left error | 45' (0.75°) or less | ||||||||||
| Caster | 2°50' ± 45' (2.83° ± 0.75°) | ||||||||||
| Right-left error | 45' (0.75°) or less | ||||||||||
| Steering axis inclination | 11°21' ± 45' (11.35° ± 0.75°) | ||||||||||
| Right-left error | 45' (0.75°) or less | ||||||||||
| Front suspension | Lower ball joint turning torque | 0.98 - 4.9 N.m (10-50 kgf.cm, 8.7 - 43 in..lbf) | |||||||||
| Stabilizer bar link ball joint turning torque | 0.05 - 0.96 N.m (0.5 - 20 kgf.cm, 0.4 - 1.7 in..lbf) | ||||||||||
|
|||||||||||
Rear Wheel Alignment Specifications
| Rear wheel alignment | Toe-in (total) | 0°16' ± 16' (0.26° ± 0.26°, 2.6 ± 2.5 mm, 0.10 ± 0.10 in.) | |
| Camber | -1°27' ± 30' (-1.45° ± 0.50°) | ||
| Right-left error | 30' (0.5°) or less |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
