Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Toyota RAV4 Base, AWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Splices
SPLICES LOCATION
| Component | Component Location |
|---|---|
| B1 | In body harness, at left front fender. |
| B2 | In body harness, above left rear wheelwell. |
| B3 | In body harness, at center of rear hatch. |
| B4 | In body harness, above right rear wheelwell. |
| E1 | In engine compartment harness, at right side of engine compartment. See Figure. |
| E2 | In engine compartment harness, at top of engine. See Figure. |
| E3 | In engine compartment harness, at rear of engine. See Figure. |
| E4 | In engine compartment harness, at rear of engine. See Figure. |
| E5 | In engine compartment harness, at left side of engine compartment. See Figure. |
| I1 | In dash harness, behind right side of dash. |
| I2 | In dash harness, behind right side of dash. |
| I3 | In dash harness, behind right side of dash. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
