Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Toyota 4Runner BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Component Location |
|---|---|
| A/C Dual Pressure Switch | On right rear of engine compartment. See Figure. |
| Back-Up Light Switch | Integral to park/neutral position switch. |
| Brake Fluid Level Warning Switch | On brake fluid reservoir. See Figure. |
| Buckle Switch (Left/Right) | In respective front seat belt buckle. |
| Detection Switch (Transfer H4L Position) | On transmission/transfer case assembly. See Figure. |
| Detection Switch (Transfer L4 Position) | On transmission/transfer case assembly. See Figure. |
| Detection Switch (Transfer Neutral Position) | On transmission/transfer case assembly. See Figure. |
| Detection Switch (Transfer 4WD Position) | On transmission/transfer case assembly. See Figure. |
| Engine Hood Courtesy Switch | Left front of engine compartment, at grille. |
| Moon Roof Control Relay & Switch | Above headliner, on top front center of roof. See Figure. |
| Oil Pressure Switch | On left side of engine. See Figure. |
| Parking Brake Switch | Under center console. |
| Park/Neutral Position Switch | On transmission. See Figure. |
| Power Steering Oil Pressure Switch | On right front of engine. See Figure. |
| Stoplight Switch | Under left side of dash. |
| 2-4 Select Switch | Under front of center console. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
