2001 Toyota RAV4 Base, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Test No. 30: All Functions Of Keyless Entry System Does Not Operate

  1. Perform TEST "A"; ONLY WIRELESS CONTROL FUNCTION INOPERATIVE under SYSTEM TESTS in KEYLESS ENTRY SYSTEMS - RAV4 article.
  2. Check wiring harness and electrical connectors passenger's side Junction Block (J/B) Electronic Control Unit (ECU) and wireless door control receiver. See WIRING DIAGRAMS in REMOTE KEYLESS ENTRY SYSTEMS - RAV4 article. Passenger's side J/B ECU is located at passenger's side of instrument panel. See Figure. Wireless door control receiver is located near driver's side of vehicle and contains a 5-pin electrical connector. See Fig 1. Wireless door control receiver may also be referred to as wireless door lock ECU. If wiring harness and electrical connectors are okay, go to next step. If wiring harness or electrical connector are defective, repair as necessary and recheck keyless entry system operation.
  3. Check passenger's side J/B ECU for proper voltage and input signals. See PASSENGER'S SIDE JUNCTION BLOCK ELECTRONIC CONTROL UNITΒ  under PIN VOLTAGE TESTS. If proper voltage and input signals exist, go to next step. If proper voltage and input signals do not exist, repair as necessary and recheck keyless entry system operation.
  4. Replace passenger's side J/B ECU with a known-good passenger's side J/B ECU and recheck keyless entry system operation. If keyless entry system operates properly, original passenger's side J/B ECU was defective. If keyless entry system still does not operate properly, check wiring harness and electrical connectors for passenger's side J/B ECU and keyless entry system components for intermittent problem. See WIRING DIAGRAMS in POWER DOOR LOCKS - TRUCKS (EXCEPT SEQUOIA) article and REMOTE KEYLESS ENTRY SYSTEMS - RAV4 article. Repair wiring harness or electrical connector as necessary.
    Fig 1: Locating Wireless Door Control Receiver
    G00025326Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.