Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Toyota RAV4 Base, AWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Power Window Motor
- Remove door panel for access to electrical connector at power window motor. Disconnect electrical connector for power window motor.
- Using jumper wires, apply battery voltage and ground to terminals No. 4 and 5 on electrical connector for power window motor and check that power window motor rotates clockwise. Perform STEP 1 in illustration. See Fig 1.
- Reverse jumper wires so polarity is reversed and check that power window motor rotates counterclockwise. Perform STEP 2 in illustration. See Fig 1. Replace power window motor if operation is not as specified. See POWER WINDOWS - TRUCKS article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.