Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Toyota PriusFACTORY OEM SERVICE PROCEDURE
Daytime Running Light Relay
NOTE:
Daytime running light relay may also be referred to as daytime running light relay (main). Manufacturer does not provide individual component testing for daytime running light relay, as only circuit testing for daytime running light relay is available.
- Ensure ignition is off. Disconnect 20-pin electrical connector at daytime running light relay. Daytime running light relay is located near driver's side of instrument panel. See Figure.
- Note electrical terminal identification on electrical connector for daytime running light relay. See Fig 1. Using ohmmeter and voltmeter, perform circuit tests at specified terminals under specified conditions. See Fig 1. If any reading is not within specification, check wiring circuit as necessary. See WIRING DIAGRAMS in DAYTIME RUNNING LIGHTS article. If all readings are within specification, replace daytime running light relay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
