Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Toyota PriusFACTORY OEM SERVICE PROCEDURE
Setting/Unsetting Auto Lock Function: Avalon
NOTE:
Auto lock function is activated or deactivated when body ECU receives inputs in a given sequence.
- With ignition switch in ON position, open driver's door. Turn ignition switch off and remove key. Insert key into ignition lock cylinder, turn ignition switch on, turn ignition switch off, and remove key from ignition lock cylinder. Repeat inserting, turning ignition switch on and off, and removing ignition key from ignition lock cylinder a total of 5 times within 10 seconds.
- Press unlock side of door lock manual switch 5 times within 10 seconds after completion of step Β 1. The function is deactivated 10 seconds later.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
