Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Toyota MR2 C56MFACTORY OEM SERVICE PROCEDURE
Window Lock Switch
- Window lock switch is located driver's side of instrument panel. See Figure. Disconnect electrical connector from window lock switch. Note window lock switch electrical terminal identification. See Fig 1.
- Using ohmmeter, check that continuity exists between electrical terminals No. 7 and 10 with switch button released to on position and that no continuity exists with switch button depressed to off position. Replace window lock switch if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.