Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Toyota MR2 C56MFACTORY OEM SERVICE PROCEDURE
Power Door Lock Control Switch
NOTE:
Power door lock control switch may also be referred to as door lock control switch.
- Power door lock control switch is located driver's side of instrument panel. See Figure. Disconnect electrical connector from power door lock control switch. Note power door lock control switch electrical terminal identification. See Fig 1.
- Using ohmmeter, check that continuity and no continuity is as specified between indicated power door lock control switch electrical terminals in relation to power door lock control switch position. See POWER DOOR LOCK CONTROL SWITCH CONTINUITYΒ table. Replace power door lock control switch if defective.POWER DOOR LOCK CONTROL SWITCH CONTINUITY
Switch Position Switch Terminals No. Specification LOCK 1 & 3; 5 & 6 Continuity OFF (1) (1) UNLOCK 1 & 6; 3 & 5 Continuity (1) There should be no continuity between any terminals.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
