Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Power Main Relay
NOTE:
Power main relay may also be referred to as PWR relay.
- Ensure ignition is off. Remove power main relay. Power main relay is located in fuse/relay box at driver's side of instrument panel. See Figure.
- Note identification of electrical terminals on power main relay. See Fig 1. Using ohmmeter, check that no continuity exists between terminals No. 3 and 5 on power main relay. Check that continuity exists between terminals No. 1 and 2 on power main relay.
- Using jumper wires, apply battery voltage and ground to terminals No. 1 and 2 on power main relay. Check that continuity now exists between terminals No. 3 and 5 on power main relay. See Fig 1. Replace power main relay if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.