Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Keyless Entry System Buzzer
NOTE:
Keyless entry system buzzer may also be referred to as wireless door lock buzzer.
- Disconnect electrical connector for keyless entry system buzzer. Keyless entry system buzzer is located near driver's side kick panel or near passenger's side front corner of engine compartment, just behind the headlight assembly and contains a Gray 2-pin electrical connector with White/Black and Pink/Blue wires.
- Using jumper wires, connect positive battery terminal to terminal No. 1 and negative battery terminal to terminal No. 2 on keyless entry system buzzer and check that keyless entry system buzzer operates. See Fig 1. Replace keyless entry system buzzer if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.