2001 Toyota Avalon XLFACTORY OEM SERVICE PROCEDURE

Testing Procedure

To ensure correct diagnosis and repair, testing should be done in the following sequence:

  • Record Customer Complaint

    Ensure all customer complaints or observations are recorded. Test drive vehicle with customer when necessary for malfunction verification.
  • Retrieve Diagnostic Trouble Codes

    Connect appropriate scan tool to Data Link Connector No. 3. See Figure. Retrieve diagnostic trouble codes and record any freeze frame data (if applicable). See RETRIEVING DIAGNOSTIC TROUBLE CODES .
  • Clear Trouble Codes

    Clear diagnostic trouble codes and freeze frame data. See CLEARING DIAGNOSTIC TROUBLE CODES .
  • Visual Inspection

    Inspect all connectors of suspect circuit or component. Ensure all connections are clean and tight.
  • Confirm Symptoms & Trouble Codes

    Perform road test. Determine if original symptoms are still present. Retrieve diagnostic trouble codes. See RETRIEVING DIAGNOSTIC TROUBLE CODES .
  • Diagnose & Repair Diagnostic Trouble Codes

    Perform diagnosis and repair procedures under DIAGNOSTIC TESTS  as necessary. For DTC descriptions, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  table under DIAGNOSTIC TROUBLE CODE DEFINITIONS. If no diagnostic trouble codes are present, proceed to TROUBLE SHOOTING - NO CODES article for diagnosis by symptom (i.e., ROUGH IDLE, NO START, etc.).
  • Verification Procedure

    After repairs have been completed, clear all diagnostic trouble codes. See CLEARING DIAGNOSTIC TROUBLE CODES . Perform road test. Ensure no diagnostic trouble codes are present and all symptoms and/or complaints have been repaired.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.