2001 Toyota 4Runner BaseFACTORY OEM SERVICE PROCEDURE

Power Mirror Control System: Inspection

WARNING: This page is about a different car, the 2002 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Mirror Control Switch & Terminals
G01909044Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Left Side, inspect mirror control switch continuity  :
    Fig 2: Mirror Control Switch Specifications (Left Side)
    G01909042Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Right Side, inspect mirror control switch continuity  :
    Fig 3: Mirror Control Switch Specifications (Right Side)
    G01909043Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If the continuity is not as specified, replace the switch.

  3. Inspect mirror motor  :
    1. Connect the positive (+) lead from the battery to terminal 1 and negative (-) lead to terminal 4, then check that the mirror turns left.
      Fig 4: Testing Mirror Motor (1 Of 4)
      G01909045Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Reverse the polarity, check that the mirror turns right.
      Fig 5: Testing Mirror Motor (2 Of 4)
      G01909046Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the positive (+) lead from the battery to terminal 5 and the negative (-) lead to terminal 4, check that the mirror turns upward.
      Fig 6: Testing Mirror Motor (3 Of 4)
      G01909047Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Reverse the polarity, check that the mirror turns downward.
      Fig 7: Testing Mirror Motor (4 Of 4)
      G01909048Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the operation is not as specified, replace the mirror assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.