Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Master Switch Circuit Test: 4Runner
Disconnect power window master switch 14-pin connector. See Fig 1. Connect positive lead from battery to connector terminals No. 3 (Blue wire) and 10 (Blue/Red wire). Connect negative lead from battery to connector terminal No. 4 (White/Black wire). Check for continuity at switch. See POWER WINDOW MASTER SWITCH CIRCUIT CONTINUITY TEST (4RUNNER) , POWER WINDOW MASTER SWITCH CIRCUIT VOLTAGE TEST (4RUNNER) and POWER WINDOW MASTER SWITCH POWER SUPPLY TEST (4RUNNER) tables. If results are not as specified, replace power window master switch. See POWER WINDOW SWITCH under REMOVAL & INSTALLATION.
| Application & Switch Position | Terminals No. | ||||||
|---|---|---|---|---|---|---|---|
| Driver's Switch | |||||||
| Locked & Unlocked | |||||||
| UP | (1) 2 & 4 | ||||||
| DOWN | (1) 1 & 4 | ||||||
| Left Rear Switch | |||||||
| Locked | |||||||
| UP | (2) 11 & 4 | ||||||
| DOWN | (2) 9 & 4 | ||||||
| Unlocked | |||||||
| UP | (1) 11 & 4 | ||||||
| DOWN | (1) 9 & 4 | ||||||
| Right Rear Switch | |||||||
| Locked | |||||||
| UP | (2) 14 & 4 | ||||||
| DOWN | (2) 13 & 4 | ||||||
| Unlocked | |||||||
| UP | (1) 14 & 4 | ||||||
| DOWN | (1) 13 & 4 | ||||||
|
|||||||
| Application & Switch Position | (1) Terminals No. | ||||
|---|---|---|---|---|---|
| Driver's Switch | |||||
| Locked & Unlocked | |||||
| UP | 1 & 3 | ||||
| DOWN | 2 & 3 | ||||
| Front Passenger's Switch | |||||
| Locked & Unlocked | |||||
| UP | 7 & 10 | ||||
| DOWN | 8 & 10 | ||||
| Left Rear Switch | |||||
| Locked & Unlocked | |||||
| UP | 9 & 10 | ||||
| DOWN | 11 & 10 | ||||
| Right Rear Switch | |||||
| Locked & Unlocked | |||||
| UP | 13 & 10 | ||||
| DOWN | 14 & 10 | ||||
|
|||||
| Connector Terminal No. To Ground | Condition | Result | ||
|---|---|---|---|---|
| 3 | Constant | battery voltage | ||
| 4 | Constant | Continuity | ||
| 10 | Ignition Switch Position In LOCK Or ACC Position | (1) No Voltage | ||
| 10 | Ignition Switch In ON Position | battery voltage | ||
|
||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
