Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming Passive Mode On
Remove ignition key from lock cylinder. Ensure all doors, hood and luggage compartment are closed and unlocked. Perform all of the following within 30 seconds: trigger lock or unlock any door with key or remote keyless entry system 3 times, open driver door, lock and unlock inside driver door lock knob 3 times.
System should start force lock after 2 seconds. Perform all of the following within 20 seconds: unlock inside driver door lock knob, close and open driver door 4 times, lock and unlock inside driver door lock knob. System should start force lock after 2 seconds. Passive mode should now be active.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.