Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Toyota Tundra Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS Actuator W/ ECU (3.4L) | In right rear corner of engine compartment. See Figure. |
| ABS Actuator W/ ECU (4.7L) | In right rear corner of engine compartment. See Figure. |
| Center Air Bag Sensor Assembly | Behind lower center of dash, on transmission tunnel. See Figure. |
| Cruise Control Actuator W/ ECU (3.4L) | On right side of engine compartment. See Figure. |
| Engine Control Module (ECM) | Behind right side of dash, near "A" pillar. See Figure. |
| 4WD Control ECU (4.7L) | Behind lower right side of dash. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.