2000 Toyota RAV4 Base, AWD, StandardFACTORY OEM SERVICE PROCEDURE

Power Window Switch Continuity Test (Driver's Switch)

Using an ohmmeter, check continuity between specified terminals with driver's power window switch in specified position. See appropriate DRIVER'S POWER WINDOW SWITCH CONTINUITY TEST table. See Fig 1-Figure . If continuity is not as specified, replace power window switch. If continuity is as specified, switch is okay.

DRIVER'S POWER WINDOW SWITCH CONTINUITY TEST (LAND CRUISER)

Application & Switch Position (1) Terminals No.
Driver's Switch
Locked & Unlocked
UP 1 & 3; 2, 4 & 5
OFF 1, 2, 4 & 5
DOWN 1, 4 & 5; 2 & 3
Passenger's Switch
Locked
UP 7 & 10
OFF 7 & 8
DOWN 8 & 10
Unlocked
UP 4, 5 & 8; 7 & 10
OFF 4, 5, 7 & 8
DOWN 4, 5 & 7; 8 & 10
Left Rear Switch
Locked
UP 9 & 10
OFF 9 & 11
DOWN 10 & 11
Unlocked
UP 4, 5 & 11; 9 & 10
OFF 4, 5, 9 & 11
DOWN 4, 5 & 9; 7, 10 & 11
Right Rear Switch
Locked
UP 10 & 13
OFF 13 & 14
DOWN 10 & 14
Unlocked
UP 4, 5 & 14; 10 & 13
OFF 4, 5, 13 & 14
DOWN 4, 5 & 13; 10 & 14
(1) See Figure.
DRIVER'S POWER WINDOW SWITCH CONTINUITY TEST (RAV4)

Application & Switch Position (1) Terminals No.
2-Door
Driver's Switch
Locked & Unlocked
UP 3 & 5; 4 & 6
OFF 3, 4 & 5
DOWN 3 & 4; 5 & 6
Passenger's Switch
Locked
UP 12 & 13
OFF 12 & 14
DOWN 13 & 14
Unlocked
UP 3 & 14; 12 & 13
OFF 3, 12 & 14
DOWN 3 & 12; 13 & 14
4-Door
Driver's Switch
Locked & Unlocked
UP 1 & 3; 2, 4 & 5
OFF 1, 2, 4 & 5
DOWN 2 & 3; 1, 4 & 5
Passenger's Switch
Locked
UP 7 & 10
OFF 7 & 8
DOWN 8 & 10
Unlocked
UP 4, 5 & 8; 7 & 10
OFF 4, 5, 7 & 8
DOWN 4, 5 & 7; 8 & 10
Left Rear Switch
Locked
UP 9 & 10
OFF 9 & 11
DOWN 10 & 11
Unlocked
UP 4, 5 & 11; 9 & 10
OFF 4, 5, 9 & 10
DOWN 4, 5 & 9; 10 & 11
Right Rear Switch
Locked
UP 10 & 13
OFF 13 & 14
DOWN 10 & 14
Unlocked
UP 4, 5 & 14; 10 & 13
OFF 4, 5, 13 & 14
DOWN 4, 5 & 13; 10 & 14
(1) For RAV4 (2-door) master switch terminal locations, see Fig 1. For RAV4 (4-door) master switch terminal locations, see Figure.
DRIVER'S POWER WINDOW SWITCH CONTINUITY TEST (SIENNA & TUNDRA)

Application & Switch Position (1) Terminals No.
Driver's Switch
Locked & Unlocked
UP 1 & 4; 3 & 9
OFF 1, 3 & 4
DOWN 1 & 3; 4 & 9
Passenger's Switch
Locked
UP 8 & 9
OFF 8 & 10
DOWN 9 & 10
Unlocked
UP 1 & 10; 8 & 9
OFF 1, 8 & 10
DOWN 1 & 8; 9 & 10
(1) See Figure.
DRIVER'S POWER WINDOW SWITCH CONTINUITY TEST (TACOMA)

Application & Switch Position (1) Terminals No.
Driver's Switch
Locked & Unlocked
UP 3 & 9; 4 & 6
OFF 3, 4 & 6
DOWN 3 & 6; 4 & 9
Passenger's Switch
Locked
UP 9 & 10
OFF 7 & 10
DOWN 7 & 9
Unlocked
UP 6 & 7; 9 & 10
OFF 6, 7 & 10
DOWN 6 & 10; 7 & 9
(1) See Figure.
DRIVER'S POWER WINDOW SWITCH CONTINUITY TEST (4RUNNER)

Application & Switch Position (1) Terminals No.
Driver's Switch
Locked & Unlocked
UP 2 & 4
DOWN 1 & 4
Left Rear Switch
Locked
UP (2) 11 & 4
DOWN (2) 9 & 4
Unlocked
UP 11 & 4
DOWN 9 & 4
Right Rear Switch
Locked
UP (2) 14 & 4
DOWN (2) 13 & 4
Unlocked
UP 14 & 4
DOWN 13 & 4
(1) See Figure.
(2) Continuity does not exist at these terminals.
Fig 1: Identifying Driver's Power Window Master Switch 7-Pin Harness Connector Terminals (Land Cruiser, RAV4 4-Door & 4Runner)
G99B50758Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.