Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Toyota MR2FACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS
| Component | Component Location |
|---|---|
| BI | On right front strut tower. See Figure. |
| BJ | On right front strut tower. See Figure. |
| BK | Near right door striker. |
| BL | On left front strut tower. See Figure. |
| BM | On left front strut tower. See Figure. |
| BN | Near left door striker. See Figure. |
| EA | On left rear strut tower. See Figure. |
| EB | On rear of engine. See Figure. |
| EC | On rear of engine. See Figure. |
| ED | On right rear strut tower. See Figure. |
| IE | At left kick panel. See Figure. |
| IF | Behind left center of dash, on brace. |
| IG | Behind right center of dash, on brace. See Figure. |
| IH | At right kick panel. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
