Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Toyota MR2FACTORY OEM SERVICE PROCEDURE
Setting/Unsetting Auto Lock Function: Avalon
NOTE:
Auto lock function is activated or deactivated when body ECU receives inputs in a given sequence.
- With ignition switch in ON position, open driver's door. Turn ignition switch off, repeat inserting and removing ignition key into/from ignition lock cylinder 5 times and turning ignition lock on and off 5 times within 10 seconds.
- Press unlock side of door lock manual switch 5 times within 10 seconds after completion of step 1. The function is deactivated 10 seconds later.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.