Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Camshaft Position Sensor
CAMSHAFT POSITION SENSOR RESISTANCE
| Application | Ohms | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| Avalon | ||||||||||
| Cold (1) | 835-1400 | |||||||||
| Hot (2) | 1060-1645 | |||||||||
| Camry & Camry Solara | ||||||||||
| 2.2L 4-Cyl. | ||||||||||
| Cold (1) | 835-1400 | |||||||||
| Hot (2) | 1060-1645 | |||||||||
| 3.0L V6 | ||||||||||
| Denso Sensor (3) | ||||||||||
| Cold (1) | 835-1400 | |||||||||
| Hot (2) | 1060-1645 | |||||||||
| Wabash Sensor (3) | ||||||||||
| Cold (1) | 1690-2560 | |||||||||
| Hot (2) | 2145-3010 | |||||||||
| Celica & Corolla | ||||||||||
| Cold (1) | 835-1400 | |||||||||
| Hot (2) | 1060-1645 | |||||||||
| ECHO | ||||||||||
| Cold (1) | 1630-2740 | |||||||||
| Hot (2) | 2065-3225 | |||||||||
| Land Cruiser & RAV4 | ||||||||||
| Cold (1) | 835-1400 | |||||||||
| Hot (2) | 1060-1645 | |||||||||
| Sienna | ||||||||||
| Denso Sensor (3) | ||||||||||
| Cold (1) | 835-1400 | |||||||||
| Hot (2) | 1060-1645 | |||||||||
| Wabash Sensor (3) | ||||||||||
| Cold (1) | 1690-2560 | |||||||||
| Hot (2) | 2145-3010 | |||||||||
| Tacoma, Tundra & 4Runner | ||||||||||
| Cold (1) | 835-1400 | |||||||||
| Hot (2) | 1060-1645 | |||||||||
|
||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.