2000 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Test No. 2: Ignition Switch Power Source Circuit: Testing

  1. Check ECU-IG fuse (15-amp) and MIRR fuse (10-amp), both located in left junction block. If fuses are okay, go to next step. If either fuse is open, located and repair short circuit. See WIRING DIAGRAMSΒ . Replace fuse(s).
  2. Disconnect body ECU harness connectors. Turn ignition on. Measure voltage between body ECU harness connector I21 terminals No. 4 and 2. See Figure. Measure voltage between body ECU harness connector I21 terminal No. 4 and connector I19 terminal No. 21. If voltage is 10-14 volts on both terminals, go to next test listed. See appropriate TROUBLE SHOOTING SYMPTOMS table under TROUBLE SHOOTING. If voltage is not 10-14 volts on both terminals, go to next step.
  3. Check wiring and connectors between body ECU harness connector I21 terminal No. 4 and ground. See WIRING DIAGRAMSΒ . Repair ground circuit as necessary. If ground circuit is okay, repair wiring or connectors between battery and body ECU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.