2000 Toyota ECHO 2D Sedan, StandardFACTORY OEM SERVICE PROCEDURE

Camry Solara

  1. Slightly lower driver's window. Disconnect 10-pin harness connector from driver's power window master switch. Connect jumper wire between positive terminal of 12-volt battery and terminal No. 3 (Green wire) at master switch connector (harness side). See Figure. Connect another jumper wire between negative terminal of battery and terminal No. 4 (Red wire) at master switch connector (harness side). Window should raise to fully closed position. If window operates correctly, go to next step. If window does not operate correctly, go to POWER WINDOW MOTOR TESTΒ .
  2. Continue to apply voltage until there is an audible click from power window motor circuit breaker (within 4-40 seconds). Reverse polarity and ensure window begins to lower within about 60 seconds. If operation is not as specified, replace power window motor. See POWER WINDOW MOTORΒ  under REMOVAL & INSTALLATION. If operation is as specified, power window motor circuit breaker is okay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.