Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1999RAV4 BASE, 2D UTILITY, AWD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESENSOR RANGE CHARTSENGINE CONTROLS - SENSOR OPERATING RANGE CHARTSINTRODUCTIONCRANKSHAFT POSITION SENSOR
1999 Toyota RAV4 Base, 2D Utility, AWD, Standard
Crankshaft Position Sensor
1999 Toyota RAV4 Base, 2D Utility, AWD, StandardSECTION Crankshaft Position Sensor
For crankshaft position sensor testing, see appropriate IGNITION CHECKS in appropriate BASIC DIAGNOSTIC PROCEDURES article.
CRANKSHAFT POSITION SENSOR RESISTANCE
| Application | Ohms | |||||||
|---|---|---|---|---|---|---|---|---|
| 4-Cylinder | ||||||||
| Camry, Camry Solara & Celica | ||||||||
| Cold (1) | 985-1600 | |||||||
| Hot (2) | 1265-1890 | |||||||
| Corolla | ||||||||
| Cold (1) | 1630-2740 | |||||||
| Hot (2) | 2065-3225 | |||||||
| RAV4 | ||||||||
| Cold (1) | 985-1600 | |||||||
| Hot (2) | 1265-1890 | |||||||
| Tacoma & 4Runner | ||||||||
| Cold (1) | 1630-2740 | |||||||
| Hot (2) | 2065-3225 | |||||||
| V6 | ||||||||
| Avalon, Camry, Camry Solara, Sienna, Tacoma & 4Runner | ||||||||
| Cold (1) | 1630-2740 | |||||||
| Hot (2) | 2065-3225 | |||||||
| V8 | ||||||||
| Land Cruiser | ||||||||
| Cold (1) | 1630-2740 | |||||||
| Hot (2) | 2065-3225 | |||||||
|
||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.