1999 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

DTC P0120: Throttle Position (TP) Sensor Circuit: Notes

NOTE: If DTCs P0110, P0115, P0120, P0450 and P1120 are output together, check circuit E2 (Brown/White wire) between terminal No. 18 at ECM harness connector E6 and splice E10. Repair as necessary. See appropriate wiring diagram in WIRING DIAGRAMS article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.