Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Power Main Relay
NOTE:
Power main relay may also be referred to as the power relay.
- Remove power main relay from driver's side fuse/relay box located near driver's side kick panel. See Figure. Note terminal identification on power main relay. See Fig 1.
- Using DVOM, check that continuity exists between terminals No. 1 and 2 on power main relay. Apply battery voltage and ground to terminals No. 1 and 2 on power main relay. Also, check that continuity exists between terminals No. 3 and 5 on power main relay. Replace power main relay if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.