1999 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Ignition Switch

  1. Disconnect electrical connector from ignition switch on the steering column upper bracket. See Fig 1. Note ignition switch electrical terminal identification and ignition lock cylinder positions. See Fig 2.
  2. Using DVOM, check that continuity is as specified between indicated ignition switch electrical terminals in relation to ignition lock cylinder position. See Fig 2. See IGNITION SWITCH CONTINUITYΒ  table. Replace ignition switch if defective.
IGNITION SWITCH CONTINUITY

Switch Position Check Between Terminals Specification
LOCK (1) Open (1) Open
ACC 2 & 3 Continuity
ON 2, 3 & 4; 6 & 7 Continuity
START 1, 2 & 4; 6, 7 & 8 Continuity
(1) There should be no continuity between any terminals.
Fig 1: Locating Ignition Switch & Key Unlock Warning Switch
G98A11247Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.