Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Switch Continuity Test (Passenger's & Rear Switches)
Using an ohmmeter, check continuity between specified terminals with power window switch in specified position. See POWER WINDOW SWITCH CONTINUITY TEST (PASSENGER'S & REAR SWITCHES)Β table. See Fig 1. If continuity does not exist at specified terminals, replace appropriate power window switch.
| Application & Position | (1) Terminals No. | ||||
|---|---|---|---|---|---|
| Avalon | |||||
| UP | 1 & 2; 3 & 5 | ||||
| OFF | 1 & 2; 4 & 5 | ||||
| DOWN | 1 & 3; 4 & 5 | ||||
| Camry | |||||
| Passenger's Door | |||||
| UP | 1 & 2; 3 & 4 | ||||
| OFF | 1 & 2; 3 & 5 | ||||
| DOWN | 1 & 4; 3 & 5 | ||||
| Rear Door | |||||
| UP | 1 & 3; 4 & 5 | ||||
| OFF | 1 & 2; 4 & 5 | ||||
| DOWN | 1 & 2; 3 & 5 | ||||
| Camry Solara | |||||
| Passenger's Door | |||||
| UP | 1 & 2; 3 & 4 | ||||
| OFF | 1 & 2; 3 & 5 | ||||
| DOWN | 1 & 4; 3 & 5 | ||||
| Celica | |||||
| UP | 1 & 4; 3 & 5 | ||||
| OFF | 1 & 2; 3 & 5 | ||||
| DOWN | 1 & 2; 3 & 4 | ||||
| Corolla | |||||
| Passenger's Door | |||||
| UP | 1 & 2; 3 & 4 | ||||
| OFF | 1 & 2; 3 & 5 | ||||
| DOWN | 1 & 4; 3 & 5 | ||||
| Rear Door | |||||
| UP | 1 & 2; 3 & 4 | ||||
| OFF | 1 & 2; 3 & 5 | ||||
| DOWN | 1 & 4; 3 & 5 | ||||
|
|||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.