Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Toyota Tercel AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit Opening Relay
- Ensure ignition is off. Remove circuit opening relay. See CIRCUIT OPENING RELAY LOCATIONΒ table. See Fig 1-Fig 8
.CIRCUIT OPENING RELAY LOCATION
Application Location Camry (1) In Relay Box At Driver's Side Front Corner Of Engine Compartment, Near Battery & Air Cleaner Celica Below Passenger's Side Of Instrument Panel, Underneath Carpet, Near Center Console, Attached To Rear Of ECM Corolla Center Relay In Relay Box, Behind Driver's Side Kick Panel RAV4 Top Rear Relay In Relay Box Below Driver's Side Of Instrument Panel, Behind Kick Panel Tacoma Behind Lower Instrument Panel Cover, Next To Driver's Side Of Steering Column Tercel Near Top Right Corner Of Fuse/Relay Box Behind Driver's Side Lower Instrument Panel Cover, Near Steering Column T100 Behind Glove Box, Near Passenger's Side Kick Panel 4Runner Below Right Corner Of Fuse/Relay Box Behind Lower Instrument Panel Cover At Driver's Side Of Instrument Panel To Left Of Steering Column, Just Above Hood Release Lever (1) Circuit opening relay may be marked as CIR OPN relay in relay box. - To test circuit opening relay continuity, use ohmmeter to check for continuity and no continuity between specified terminals. See Fig 9-Fig 15 .
- To test circuit opening relay operation, apply battery voltage and ground to relay and use ohmmeter to check for continuity between specified terminals. See Fig 9-Fig 15 . Replace circuit opening relay if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
