1998 Toyota Tercel AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Pressure Release

  1. Disconnect electrical connector for electric fuel pump. See FUEL PUMP ELECTRICAL CONNECTOR LOCATIONΒ  table. Electric fuel pump is located in the fuel tank.
    FUEL PUMP ELECTRICAL CONNECTOR LOCATION

    Application Connector Location
    Camry, Celica & Corolla Under Cover Plate, Below Rear Seat
    RAV4 Under Cover Plate, Below Driver's Side Rear Seat
    Tacoma On Top Of Fuel Tank, At Fuel Pump
    Tercel Under Cover Plate, Below Rear Seat
    T100 On Top Of Fuel Tank, Near Fuel Pump
    4Runner On Top Of Fuel Tank, At Fuel Pump
  2. Start engine and allow engine to idle until engine stalls. Turn ignition off. Disconnect negative battery cable.
  3. Place suitable container under fuel line connection. Cover fuel line connection with shop towel. Slowly loosen fuel line connection, allowing fuel pressure to be released. Once fuel pressure is released, fuel system components may be serviced.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.