1998 Toyota Tercel AutomaticFACTORY OEM SERVICE PROCEDURE

Power Main Relay Test: Tercel

Remove power main relay. See POWER RELAY LOCATIONΒ  table. Using an ohmmeter, check continuity between terminals No. 1 and 3. Continuity should exist. See Figure. Apply battery voltage to terminal No. 1 and ground terminal No. 3. Continuity should exist between terminals No. 2 and 4. If relay does not test as described, replace power main relay.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.