1998 Toyota Tercel AutomaticFACTORY OEM SERVICE PROCEDURE

Integration Relay Test: Avalon

  1. Locate integration relay. See INTEGRATION RELAY LOCATIONΒ  table. Backprobing connector, connect voltmeter positive lead to terminal No. 13 at integration relay 25-pin connector. See Fig 1. Connect voltmeter negative lead to ground. Turn ignition switch to LOCK position.
  2. Observe voltmeter and close driver's door. Battery voltage should be present. Open driver's door. Voltage should be zero volts. Observe voltmeter and turn ignition switch to ON position. Battery voltage should be present. If voltage is not as specified, replace integration relay and retest.
INTEGRATION RELAY LOCATION

Application Location
Avalon & Camry Junction Block Behind Instrument Panel, Left Of Steering Column
Fig 1: Testing Integration Relay (Avalon)
G98F10830Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.