Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE
Fuel Pump Relay
NOTE:
Fuel pump relay may also be referred to as fuel pump control relay.
- Ensure ignition is off. Remove fuel pump relay. Fuel pump relay is located on passenger's side of underhood compartment, near wiper motor and contains a Gray 4-pin electrical connector. See Fig 1.
- To check fuel pump relay continuity, use ohmmeter to check continuity between specified terminals. See Fig 2. Continuity should exist between terminals +B1 and FPR, and terminals +B1 and FP. No continuity should exist between terminals +B1 and PR.
- To check fuel pump relay operation, apply battery voltage and ground to terminals +B1 and FPR on fuel pump relay. Check continuity and voltage between specified terminals. See Fig 2. No continuity should exist between terminals +B1 and FP. Voltage should exist between terminals PR and FPR. Replace fuel pump relay if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
