1997 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE

EFI Main Relay

NOTE: EFI main relay may also be referred to as EFI relay.
  1. Ensure ignition is off. Remove EFI main relay. See EFI MAIN RELAY LOCATIONΒ  table.
    NOTE: The EFI main relay may also be identified using appropriate illustration in THEORY/OPERATION article.
    EFI MAIN RELAY LOCATION

    Application Location
    Previa (1) Behind Instrument Cluster, In Relay Block Located Above Accelerator Pedal Area
    (1) EFI main relay is a round relay at lower right corner of relay block. See Figure.
  2. To check EFI main relay continuity, use ohmmeter to check continuity between specified terminals. See Fig 1.
  3. To check EFI main relay operation, apply battery voltage and ground to relay and use ohmmeter to check continuity between specified terminals. See Fig 1. Replace EFI main relay if defective.
Fig 1: Testing EFI Main Relay
G97G06279Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.