1997 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE

Air Control Valve Circuit

  1. The Engine Control Module (ECM) controls the air control valve to maintain near atmospheric pressure at front and rear bearings on supercharger. This prevents grease and oil from leaking from the supercharger, due to pressure fluctuation inside the supercharger.
  2. Check air control valve operation. See AIR CONTROL VALVE under SUPERCHARGERΒ . Replace air control valve if defective. If air control valve operates correctly, access the ECM. The ECM is located below driver's side seat leg, near emergency brake lever.
  3. Turn ignition on. Using voltmeter, check voltage between terminal No. 20 (Red/White wire) on ECM and chassis ground. See Fig 1.
  4. Voltage should be 9-14 volts. If voltage is within specification, go to next step. If voltage is not within specification, check for defective EFI main relay or wiring harness between EFI main relay and ECM. See EFI MAIN RELAYΒ  under RELAYS. See appropriate wiring diagram in WIRING DIAGRAMS article.
  5. Check for defective air hose at air control valve. The air control valve is located on bracket, near radiator. See Figure. If air hose is defective, replace air hose. If air hose is okay, check ECM ground circuit. If ECM ground circuit is okay, substitute another ECM and recheck system operation.
Fig 1: Checking Voltage For Air Control Valve At ECM
G96I09962Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.