Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE
Air Control Valve
- Remove air control valve. The air control valve is located on bracket, near radiator. See Figure. Using ohmmeter, ensure continuity exists between electrical terminals on air control valve and resistance is 30-34 ohms at 68Β°F (20Β°C). Replace air control valve if no continuity exists or resistance is not within specification.
- Ensure no continuity exists between each electrical terminal and body of air control valve. Replace air control valve if continuity exists between electrical terminal and body of air control valve.
- Apply air pressure to port "A". Ensure no air flows from ports "B" and "C". Perform STEP 1. See Fig 1. Apply battery voltage and ground to electrical terminals on air control valve.
- Apply air pressure to port "A". Ensure air flows from ports "B" and "C". Perform STEP 2. See Fig 1. Replace air control valve if defective. Reinstall ACV.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
