1997 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE

Fuel Pump Resistor

  1. Ensure ignition is off. Disconnect electrical connector at fuel pump resistor. Fuel pump resistor is located at driver's side front corner of underhood compartment, below air cleaner case and contains a Gray 2-pin electrical connector. See Fig 1.
  2. Using ohmmeter, check resistance between electrical terminals on fuel pump resistor. Replace fuel pump resistor if resistance is not .58-.70 ohm at 68Β°F (20Β°C).
Fig 1: Locating Fuel Pump Resistor
G95F33683Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.