Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Toyota Corolla Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||||
|---|---|---|---|---|---|
| Air Intake Chamber Bolt/Nut (1) | 14 (19) | ||||
| Distributor Hold-Down Bolt | 15 (20) | ||||
| ECT Sensor | (2) | ||||
| Fuel Inlet Hose-To-Fuel Rail Union Bolt | 21 (29) | ||||
| Fuel Outlet Line-To-Fuel Pump Mounting Bracket | 22 (30) | ||||
| Fuel Rail-To-Intake Manifold Bolt | 11 (15) | ||||
| Oxygen Sensor-To-Exhaust Pipe | 33 (45) | ||||
| Throttle Body Bolt/Nut | 16 (22) | ||||
| Vehicle Speed Sensor Retaining Bolt | 12 (16) | ||||
| INCH Lbs. (N.m) | |||||
| Crankshaft Position Sensor Bolt | 82 (9.3) | ||||
| EGR Valve Retaining Nut | 115 (13.0) | ||||
| Fuel Pressure Regulator Bolt | 82 (9.3) | ||||
| Fuel Pump Mounting Bracket-To-Fuel Tank Bolt | 30 (3.4) | ||||
| PNP Switch Retaining Bolt | 48 (5.4) | ||||
| PNP Switch Retaining Nut | 61 (6.9) | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.