Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Toyota 4Runner Base, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Cruise Control System DTCS
CRUISE CONTROL SYSTEM DTCS (2.7L)
| OEM Code | Test Procedures | Description | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| 11 | 123(2), (3) | Short In Actuator Motor Circuit | ||||||||
| 12 | 123(2), 7(3) | Open In Actuator Magnetic Clutch Ckt For 0.8 Second | ||||||||
| 12 | 123(2),7(3) | Short In Actuator Magnetic Clutch Ckt | ||||||||
| 13 | 123(2), (3) | Actuator Position Sensor Detects Abnormal Voltage | ||||||||
| 14 | 123(2), (3) | Open In Actuator Motor Circuit | ||||||||
| 14 | 123(2), (3) | Position Sensor Signal Value Does Not Change When Motor Operates | ||||||||
| 21 | 4(2), (3) | Speed Sensor Signal Not Sent When Cruise Control Is Set | ||||||||
| 23 (4) | 4(2), (3) | Vehicle Speed Sensor Pulse Abnormal | ||||||||
| 32 | 56(2), (3) | Short In Cruise ON-OFF (Main) Switch Ckt | ||||||||
| 41 | (2), (3) | Faulty Cruise Control ECU | ||||||||
| 42 | 1213 | Source Voltage Drop | ||||||||
| Normal | None | Indicator Light Flashes On & Off | ||||||||
|
||||||||||
CRUISE CONTROL SYSTEM DTCS (3.4L)
| OEM Code | Test Procedure | Description | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| 11 | 12(2), (3) | Short In Actuator Motor Circuit | ||||||||
| 12 | 12(2),7(3) | Open In Actuator Magnetic Clutch Ckt For 0.8 Second | ||||||||
| 12 | 12(2),7(3) | Short In Actuator Magnetic Clutch Ckt | ||||||||
| 14 | 12(2), (3) | Open In Actuator Motor Circuit | ||||||||
| 14 | 12(2), (3) | Position Sensor Signal Value Does Not Change When Motor Operates | ||||||||
| 15 | 12(2), (3) | Open In Actuator Motor Circuit | ||||||||
| 21 | 4(2), (3) | Speed Sensor Signal Not Sent When Cruise Control Is Set | ||||||||
| 23 (4) | 4(2), (3) | Vehicle Speed Sensor Pulse Abnormal | ||||||||
| 32 | 56(2), (3) | Short In Cruise ON-OFF (Main) Switch Ckt | ||||||||
| 41 | (2), (3) | Faulty Cruise Control ECU | ||||||||
| 42 | 1213 | Source Voltage Drop | ||||||||
| 51 | 8(2), (3) | Short In Idle Signal Circuit | ||||||||
| Normal | None | Indicator Light Flashes On & Off | ||||||||
|
||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
