Throttle Position (TP) Sensor

1996 Toyota Tercel DX, 4D Sedan, AutomaticSECTION Throttle Position (TP) Sensor
TPS RESISTANCE SPECIFICATIONS

Application Clearance In. (mm) Terminal Ohmmeter Reading
1.5L (1) 0 (0) VTA & E2 200-5700
" .020 (.50) IDL & E2 2300 Or Less
" .028 (.70) IDL & E2 No Continuity
" Fully Open VTA & E2 2000-10,200
" " VC & E2 2500-5900
(1) On A/T models, disconnect throttle cable from linkage before checking TP sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.