Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE
Fuel Pump Relay
NOTE:
Fuel pump relay may also be referred to as fuel pump control relay.
- Ensure ignition is off. Remove fuel pump relay, located on passenger's side of underhood compartment, near wiper motor and contains a Gray 4-pin electrical connector. See Fig 1.
- To test fuel pump relay continuity, using ohmmeter, check continuity between specified terminals. See Figure.
- To test fuel pump relay operation, apply battery voltage and ground to relay. Check continuity and voltage between specified terminals. See Figure. No continuity should exist between +B1 and FP terminals. Voltage should exist between PR and FPR terminals. Replace fuel pump relay if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
