1996 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE

Air Control Valve

  1. Remove Air Control Valve (ACV). The air control valve is located on bracket, near radiator. See Figure. Using ohmmeter, ensure continuity exists between electrical terminals on ACV and resistance is 30-34 ohms. Replace ACV if no continuity exists or resistance is not within specification.
  2. Ensure no continuity exists between each electrical terminal and body of ACV. Replace ACV if continuity exists between electrical terminal and body of ACV.
  3. Apply air pressure to port "A". Ensure no air flows from ports "B" and "C". Perform STEP 1. See Fig 1. Apply battery voltage and ground to electrical terminals on ACV.
  4. Apply air pressure to port "A". Ensure air flows from ports "B" and "C". Perform STEP 2. See Fig 1. Replace ACV if defective. Reinstall ACV.
Fig 1: Checking Air Control Valve
G94J45806Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.