Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE
Ignition Timing
- Start and warm engine to normal operating temperature. Shut engine off. Connect timing light to spark plug wire on cylinder No. 1 (front cylinder at timing chain end of engine). Remove upper panel from instrument panel and connect scan tester to data link connector No. 3. See Fig 1. Scan tester is used to read engine RPM.
- Apply parking brake. Place transmission in Neutral. Start engine and maintain engine at 2500 RPM for 90 seconds and then allow engine to idle. Ensure idle speed is 700-800 RPM.
- Install Jumper Wire (SST 09843-18020) between terminals TE1 and E1 of data link connector No. 1. See Fig 2.NOTE: Timing marks are located on lower side of front cover.
- Ensure base timing is within specification at idle with transmission in Neutral, and with A/C and all accessories off. See IGNITION TIMINGΒ table.
- Remove jumper wire from data link connector No. 1. Ensure ECM controlled timing is within specification. See IGNITION TIMINGΒ table. Shut engine off. Remove jumper wire, timing light and scan tester.
IGNITION TIMING (Degrees BTDC @ Idle) (1)
| Application Type | (2) Base Timing | (3) ECM Controlled Timing | ||||||
|---|---|---|---|---|---|---|---|---|
| Previa | 5 | 7-17 | ||||||
|
||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
