Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Toyota Paseo AutomaticFACTORY OEM SERVICE PROCEDURE
EFI Main Relay
NOTE:
EFI main relay may also be referred to as EFI relay.
- Ensure ignition is off. Remove EFI main relay. See EFI MAIN RELAY LOCATION table.NOTE: The EFI main relay may also be identified using appropriate illustration in THEORY/OPERATION article.EFI MAIN RELAY LOCATION
Application Location Paseo In Large Fuse/Relay Box Near Driver's Side Front Corner Of Engine Compartment - To test EFI main relay continuity, using ohmmeter, check continuity between specified terminals. See Fig 1 and Fig 2.
- To test EFI main relay operation, apply battery voltage and ground to relay and use ohmmeter to check continuity between specified terminals. See Fig 1 and Fig 2. Replace EFI main relay if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.