1996 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Checking Fuel Pump Operation Using Scan Tester

  1. Remove cover (if equipped) and install scan tester on data link connector No. 3. See Figure. Turn ignition on. DO NOT start engine.
  2. Using scan tester manufacturer's instructions, activate fuel pump. Listen for fuel pump operating sound and feel for pressure in fuel inlet line near fuel filter. Turn ignition off. Remove scan tester. If fuel pump operates, check fuel pressure. See FUEL PRESSUREΒ .
  3. If fuel pump does not operate, EFI main relay, circuit opening relay or fuel pump relay (if used) may be defective. For relay application and explanation of relay operation, see FUEL PUMP CONTROL CIRCUITΒ .
  4. If relays are okay, check wiring circuit and fuses. If fuel pump does not operate, check for defective fuel pump or defective fuel pump ground circuit. See appropriate wiring diagram in WIRING DIAGRAMS article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.