Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Toyota 4Runner Base, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Cruise Control Systems DTCS
CRUISE CONTROL SYSTEMS DTCS
| OEM Code | Test Procedures | Description | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 11 | 123(2)(3) | Overcurrent (Short) In Motor Circuit | ||||||||||||
| 12 | 123(2)7(3) | Open In Magnet Clutch Circuit For 0.8 Second | ||||||||||||
| 12 | 123(2)7(3) | Overcurrent (Short) In Magnet Clutch Circuit | ||||||||||||
| 13 (4) | 123(2)(3) | Actuator Position Sensor Detects Abnormal Voltage | ||||||||||||
| 14 | 123(2)(3) | Open In Actuator Motor Circuit | ||||||||||||
| 14 | 123(2), (3) | Position Sensor Signal Value Does Not Change When Motor Operates | ||||||||||||
| 15 (5) | 123(2), (3) | Open In Actuator Motor Circuit | ||||||||||||
| 21 | 4, (2), (3) | Speed Sensor Signal Not Sent To CC ECU For 140 Milliseconds Or Longer | ||||||||||||
| 23 (6) | 4(2), (3) | Vehicle Speed Sensor Pulse Abnormal | ||||||||||||
| 32 | 56(2)(3) | Short In CRUISE ON-OFF (MAIN) Switch | ||||||||||||
| 41 | (2), (3) | Faulty Cruise Control ECU | ||||||||||||
| 42 | 1213 | Source Voltage Drop | ||||||||||||
| 51 (5) | 8(2)(3) | Short In Idle Signal Circuit | ||||||||||||
| Normal | None | Indicator Light Flashes On & Off | ||||||||||||
|
||||||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
