1996 Toyota 4Runner Base, 4WD, AutomaticFACTORY OEM SERVICE PROCEDURE

Cruise Control Systems DTCS

CRUISE CONTROL SYSTEMS DTCS

OEM Code Test Procedures Description
11 123(2)(3) Overcurrent (Short) In Motor Circuit
12 123(2)7(3) Open In Magnet Clutch Circuit For 0.8 Second
12 123(2)7(3) Overcurrent (Short) In Magnet Clutch Circuit
13 (4) 123(2)(3) Actuator Position Sensor Detects Abnormal Voltage
14 123(2)(3) Open In Actuator Motor Circuit
14 123(2), (3) Position Sensor Signal Value Does Not Change When Motor Operates
15 (5) 123(2), (3) Open In Actuator Motor Circuit
21 4, (2), (3) Speed Sensor Signal Not Sent To CC ECU For 140 Milliseconds Or Longer
23 (6) 4(2), (3) Vehicle Speed Sensor Pulse Abnormal
32 56(2)(3) Short In CRUISE ON-OFF (MAIN) Switch
41 (2), (3) Faulty Cruise Control ECU
42 1213 Source Voltage Drop
51 (5) 8(2)(3) Short In Idle Signal Circuit
Normal None Indicator Light Flashes On & Off
(1) Perform test numbers in order given.
(2) Check wiring harness and connectors.
(3) Check CC ECU. See CRUISE CONTROL ECU CIRCUIT TEST Replace CC ECU as necessary.
(4) 4-cylinder models only.
(5) V6 models only.
(6) If speed set can be maintained when CRUISE ON-OFF (MAIN) switch is again set to SET/COAST position, there is no malfunction.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.