Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Toyota Tercel Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Crankshaft Position Sensor
- Disconnect electrical connector for crankshaft position sensor. Electrical connector is located near oil dipstick. See Fig 1. Crankshaft position sensor is located behind lower timing belt cover, near sprocket on crankshaft.
- Using ohmmeter, measure resistance between electrical terminals on electrical connector for crankshaft position sensor. See Fig 1.
- Replace crankshaft position sensor if resistance is not 985-1600 ohms at 14-122°F (-10-50°C) and 1265-1890 ohms at 122-212°F (50-100°C). Reinstall electrical connector for crankshaft position sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.