Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Toyota Tercel Base, AutomaticFACTORY OEM SERVICE PROCEDURE
DTC Definitions: Notes
NOTE:
Speed sensor diagnostics and code retrieval use different DLC1 terminals with service connector or short pin connected. If a speed sensor or speed sensor circuit problem is suspected, see SPEED SENSOR DIAGNOSTICS .
Check suspected components in given order. See COMPONENT TESTING. Checks consist mainly of visual inspection and continuity tests.
DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | DESCRIPTION |
|---|---|
| Code 11 | Open In Solenoid Relay Circuit |
| Code 12 | Short In Solenoid Relay Circuit |
| Code 13 | Open In Pump Motor Relay Circuit |
| Code 14 | Short In Pump Motor Relay Circuit |
| Code 21 | Open Or Short Circuit In Solenoid For Right Front Wheel |
| Code 22 | Open Or Short Circuit In Solenoid For Left Front Wheel |
| Code 23 | Open Or Short Circuit In Solenoid For Right Rear Wheel |
| Code 24 | Open Or Short Circuit In Solenoid For Left Rear Wheel |
| Code 31 | Malfunction Of Right Front Wheel Speed Sensor Signal |
| Code 32 | Malfunction Of Left Front Wheel Speed Sensor Signal |
| Code 33 | Malfunction Of Right Rear Wheel Speed Sensor Signal |
| Code 34 | Malfunction Of Left Rear Wheel Speed Sensor Signal |
| Code 35 | Open In Left Front Or Right Rear Wheel Speed Sensor Circuit |
| Code 36 | Open In Right Front Or Left Rear Wheel Speed Sensor Circuit |
| Code 37 | Malfunction In Both Rear Axle Hubs |
| Code 41 | Abnormally High Or Low Battery Voltage (Less Than 9.5 Volts Or Greater Than 16.2 Volts) |
| Code 51 | Actuator Pump Motor Is Locked, Or Pump Motor Circuit Is Open |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
