1995 Toyota Tercel Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor

For terminal identification and testing procedures, see the SYSTEM/COMPONENT TESTS article.

1.5L TPS RESISTANCE SPECIFICATIONS (1)

Clearance: In. (mm) Terminals Ohms
0 (0) VTA & E2 200-5700
.020 (.51) IDL & E2 2300 Or Less
.028 (.71) IDL & E2 No Continuity
Fully Open VTA & E2 2000-10,200
" VC & E2 2500-5900
(1) On A/T models, disconnect throttle cable from linkage before checking TPS.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.